AS1602

EMI/ESD Protection

  • Enables system designers to comply with:
  • CISPR22 and FCC Part 15, Class B requirements for Radiated and Conducted Emissions.
  • IEC 61000-4-3/6 requirements for Radiated and Conducted Immunity, Level 3 or higher.
  • IEC 61000-4-2 ESD (Air Discharge) of ±25kV.
  • IEC 61000-4-2 ESD (Contact Discharge) of ±12kV.
  • Cable Discharge Event (CDE) of ±12kV.
  • Provides up to 10dB of additional common mode noise suppression over the frequency of 1MHz to 125MHz when used with Ethernet magnetics.
  • Robust built-in ESD suppressors protect the Ethernet Phy and improve system ESD performance.
  • JESD22-A114, ESD, HBM of ±8kV.
  • Interfaces to standard Ethernet transformers and 10/100/
  • 1000 Ethernet PHYs.
  • Uses a single standard power rail (3.3V or 2.5V).
  • Open drain output stage that can be biased from 1.8V to 3.3V using transformer center-tap supply as needed based on choice of Ethernet Phy.
  • Flow-through routing for ease of board layout.
  • Typical power consumption of 90mW.
  • Low power mode available for tight power budgets.
  • Industrial temperature range (-40°C to 85°C).

Key Applications

  • Ethernet systems requiring additional CM suppression to meet EMC Class B emissions or higher EMI immunity requirements and ESD protection.
  • POE and Non-POE Ethernet systems
  • VoIP Phones, IP Cameras, WAPs, Routers, Switches
  • Set Top Boxes, Networked Printers and Appliances,
  • Desktop and Laptop Computers